Bootloader Mode; Register; Figure 2: Register Of Bootloader Mode - Semtech TS8000 User Manual

TS8X Series Device GUI Loaded Device
User Manual
POWER PRODUCTS
In TRANSMITTER Mode, there are 2 tabs including Register, Configuration,
Calibration, Firmware, for customer to adjust parameters to Tx or read information
from Tx.
(Note: the Api in BOOTLOADER and in TRANSMITTER may different)

2 BOOTLOADER mode

In BOOTLOADER Mode, there are 5 tabs including Register, Api, Configuration,
Calibration, Firmware, for customer to adjust parameters to Tx or read information
from Tx.
But in TRANSMITTER Moder, there is only 1 tab of Reigister available.

2.1 Register

Figure 2: Register of BOOTLOADER Mode

The register is read-only if its R/W property is R. The register is read-write if its R/W
property is R/W.
Click button to read corresponding register. Click button to read all
registers. Check to read all resiger automatically.
To change setting of a read-write register, double click its Value or Bit Field to open
Bit Value Edit window.
Rev 1.2
© 2015 Semtech Corp. www.semtech.com
6 of 12