Table of Contents
Advertisement
POWER PRODUCTS
3. Connect DC 19V power, then Tx board is now connected to GUI
1.3 Adjust Parameters
In BOOTLOADER Mode, there are 4 tabs including Register, Configuration,
Calibration, Firmware, for customer to adjust parameters to Tx or read information
from Tx.
Refer to "Page Error: Reference source not found, Chapter Error: Reference source
not found Error: Reference source not found" for more detail.
1.4 Run Tx Mode
After you confirm and save all the parameters in above procedures, you can run Tx
with your new parameters in TRANSMITTER Mode.
1. Unplug power supply
2. Unplug Tx micro USB from PC
3. Plug power supply
4. Now Tx board is running in TRANSMITTER Mode.
1.5 Toggle Tx between BOOTLOADER and TRANSMITTER
Mode
Tx can be toggled running between BOOTLOADER Mode and TRANSMITTER
Mode by selecting Mode in GUI without plug/unplug any cable.
Make sure the Com it kept in USB-HID, otherwise Tx will lose connection.
User changes parameters in BOOTLAODER Mode, then switch to TRANSMITTER
mode to evaluate the chagnes. This feature is very convient for user to fine tune
parameters between BOOTLAODER and TRANSMITTER mode.
1.6 Adjust Parameters and run APIs
In BOOTLOADER Mode, there are 5 tabs including Register, Configuration,
Calibration, Firmware, for customer to adjust parameters to Tx or read information
from Tx.
Rev 1.2
TS8X Series Device GUI Loaded Device
© 2015 Semtech Corp.
5 of 12
User Manual
www.semtech.com
Advertisement
Table of Contents
