Table of Contents
Advertisement
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device C joins the IRF fabric after reboot.
Configure Device D
4.
# Set the member ID of Device D to 4, create IRF ports 1 and 2, and bind them to physical ports
Ten-GigabitEthernet 2/0/1 and Ten-GigabitEthernet 2/0/2 respectively.
<Sysname> system-view
[Sysname] irf member 4
Info: Member ID change will take effect after the switch reboots and operates in IRF mode.
[Sysname] irf-port 1
[Sysname-irf-port1] port group interface ten-gigabitethernet 2/0/1
[Sysname-irf-port1] quit
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 2/0/2
# Save the current configuration to the startup configuration file.
[Sysname] quit
<Sysname> save
# Connect Device D to Device B and Device C as shown in
# Switch the operating mode of Device D to IRF.
<Sysname> system-view
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup. Continue?
[Y/N]:y
Do
you
want
to
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device D joins the IRF fabric after reboot. Now, the IRF fabric has four member switches.
Configure BFD MAD
5.
# Create VLAN 3, and add ports GigabitEthernet 1/2/0/1, GigabitEthernet 2/3/0/1, GigabitEthernet
3/3/0/1, and GigabitEthernet 4/3/0/1 to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] port gigabitethernet 1/2/0/1 gigabitethernet 2/3/0/1 gigabitethernet
3/3/0/1 gigabitethernet 4/3/0/1
[Sysname-vlan3] quit
# Create VLAN-interface 3 and configure a MAD IP address for the interface.
[Sysname] interface vlan-interface 3
[Sysname-Vlan-interface3] mad bfd enable
convert
the
content
51
Figure
17.
of
the
next
startup
configuration
file
Hide quick links:
Advertisement
Table of Contents
