Absco 30302GK Assembly Instructions Manual page 12

ABSCO ASSEMBLY INTRODUCTION
The snaptite assembly system locks most perimeter channels to all roof and wall
sheets without the need for tools and fasteners.
PUSH
Position sheets on timbers,
trestles or partly over edge of
concrete slab.
FASTENING SYMBOLS
D
Join components together by pre-drilling the holes
first. Use one component as a template to mark where
the holes are. Drill with 3mm drill bit.
Join components together with one screw at this
location only, as some channel sections have extra
holes that are not required for this model of garden
shed
Do not join components together at this location yet,
as the screw may obstruct further assembly of other
components
ABSCO INDUSTRIES
Premier Garden Shed -
Model: 30302GK
To pre-assemble the four wall panels
and two roof panels, the perimeter
channels are secured to the top and
bottom of each panel using the
snaptite system, as detailed on the
following pages wherever you see
the symbol.
SNAP
After joining sheets together, position channel over one end of the sheets, gently
tapping it over the snaptite lugs, working along the sheets to the other end.
PUSH
ASSEMBLY INSTRUCTION - MODEL: 30302GK 27/04/16
T TE
i
Each perimeter channel must finish flush with the
edges of the sheets.The snaptite system allows
adjustment for this process by simply tapping the
channel along the sheets until each end is neatly
flush. If you need to remove channels from the
panels, pull the channel along the panel from
opposing ends. You may need someone to help
with this.
3mm POP RIVETS
4mm NUT & BOLT SET
PAGE 12