Switching The Under-Bench Air Conditioner On And Off; Selecting The Air Conditioning Mode - Dometic FreshWell 3000 Operating Manual

Operating the under-bench air conditioner
8.4

Switching the under-bench air conditioner on and off

I
NOTE
• When it is switched on, it begins to condition the air to the values that
were set most recently.
• You can use the remote control to switch the under-bench air
conditioner to and from stand-by mode. Press the
• You can operate the under-bench by remote control and via LIN bus.
If you use LIN bus control the receiver is not required.
• Don't use the under-bench air conditioner if the vehicle is tilted more
than 10°.
When you switch on the under-bench air conditioner, the device waits a few minutes
before operating the compressor.
8.5

Selecting the air conditioning mode

I
NOTE
The under-bench air conditioner must be switched on.
➤ Select the air conditioning mode of your choice using the MODE key, see
chapter "Air conditioning modes" on page 16.
✓ The under-bench air conditioner confirms the receipt of the values with a high
note.
✓ The under-bench air conditioner is switched to the selected air conditioning
mode.
20
FreshWell3000
button.
EN