Extron electronics HAE 100 4K Setup Manual

HAE 100 4K • Setup Guide
The Extron HAE 100 4K is an audio de-embedder that extracts the audio from an HDMI signal, including audio from 4K sources.
The HAE 100 4K provides an analog output for stereo or dual mono signals, as well as a S/PDIF digital audio output that supports
two-channel or digital multi-channel signals.
Mounting
The HAE 100 4K can be placed on a desktop or tabletop using the included rubber feet, or mounted to a rack or furniture (see the
HAE 100 4K User Guide, available at www.extron.com, for mounting options and instructions).
Cabling
Rear Panel Features and Cabling
POWER
12V
0.6A MAX
E 100 4K
INPUT
A A B B
HAE 100 4K Rear Panel
Figure 1.
A
Power input — Connect the provided power supply to the 3.5 mm, 2-pole captive
screw power receptacle (see the image at right).
ATTENTION:
• Do not connect the power supply before reading the Attention in the
Power Supply section of the HAE 100 4K User Guide.
• Ne branchez pas la source d'alimentation externes avant d'avoir lu
les mises en garde dans la section « Power Supply » du HAE 100 4K
User Guide.
B
HDMI input — Connect an HDMI input source into this female HDMI type A connector.
NOTE: By default, the EDID stored at the HDMI input is set to 720p at 60 Hz with 2-channel audio. EDID can be
configured using Extron PCS software or SIS commands (see
C
HDMI output — Connect an HDMI output device into this female HDMI type A connector.
NOTE: It is not required to connect an HDMI output device to extract audio from the HDMI input device.
D
S/PDIF audio output — Connect a S/PDIF audio output device into this female RCA connector. This connector outputs
digital S/PDIF audio formats (2-channel LPCM, Dolby Digital, or DTS).
NOTE: By default, the audio input format is configured for 2-channel audio. In this configuration, the S/PDIF and
Analog outputs are active, but only 2-channel audio will pass. The audio setting can be configured using PCS or
SIS commands (see
E
Analog audio output — Connect an audio output device to this 5-pole 3.5 mm captive screw connector (see figure 2 below
for connector wiring).
NOTE: By default, this output is configured for stereo audio.
SIS commands (see
Do not tin the wires!
Analog Output Connector Wiring
Figure 2.
HAE 100 4K
ANALOG
S/PDIF
L
OUTPUT AUDIO OUTPUTS
C C D D E E
Configuration on the next page).
Configuration on the next page).
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Output
R
Configuration
It can be configured for dual mono audio
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
3/16"
(5 mm) Max.
Smooth
Ridges
A A
Captive Screw
Connector
SECTION A–A
Power Supply
Output Cord
on the next page).
using PCS or