Project Nursery PNM4N11 Quick Start Manual

Charge the monitor
Unpack
1 2
Parent monitor
Wireless camera
The accessories:
(2) 10-foot charging cables
(2) power adapters
Check out our setup videos
On your computer, go to
ProjectNursery.com/Electronics or
scan the QR code here.
Position the camera(s)
3
Find a location for the camera(s) that gives you
Find one of the charging
cables included in this the best view of your baby in his or her crib.
package.
Plug one end of this cable
into the USB CHARGING
jack on the side of the
parent monitor.
Plug the other end of the
charging cable into one
of the included charging
adapters. Then plug the
Place the camera(s) on a flat surface, like a dresser
adapter into an outlet or
or shelf, or mount the camera to a wall using the
surge protector.
keyhole slots on its bottom.
IMPORTANT: NEVER place the camera(s) or
cords of any kind inside the crib. NEVER place the
camera(s) or cords within reach of the baby. They
should be at least 3 feet away.
WARNING
Strangulation Hazard: Children have STRANGLED in cords. Keep
this cord out of the reach of children (more than 3ft (1m) away).
Never use extension cords with AC Adapters. Only use the AC
Adapters provided.
Plug in the camera(s) Turn on the camera
4 5
Find the other charging cable(s) included in this
package.
Plug one end into the
CHARGING jack on the
back of the camera(s).
Congratulations!
monitor (if it isn't, see the instructions in the owner's manual to pair it). It's a good idea to go ahead and
set the time on your parent monitor now, before you start using it. For information on how to use your
new system, see the owner's manual or the other side of this quick start guide.
Plug the other end into the
Set the time on the parent monitor
7
single charging adapter.
Then plug the adapter
1
into an outlet or surge
protector.
2
Important Note About
72º
Camera Position
Position the camera as shown here,
with the neck slanting away from
the camera face. This gives the best
range of movement.
Turn on the monitor
6
Press the POWER Press and hold the
button on the back of POWER button on the
the camera to turn the parent monitor for three
camera on. seconds to turn the
parent monitor on.
Your system is ready to use! The camera(s) comes pre-paired with your parent
3
Press the MENU
72º 12:00AM
button on the parent
Temperature
Time Set
monitor. The menu
Factory Reset
Support
appears on screen. Product Information
Use the arrows
4
Use the up/down arrow buttons to set the
to highlight
12:00AM
hours, minutes, and AM/PM. Press OK/ZOOM
SETTINGS. Press
when you're finished.
OK/ZOOM to select
it. The Settings
menu appears on 72º 12:00AM
Temperature
screen.
Time Set Time: 12:00 AM
Factory Reset
Support
Product Information
Press the
down arrow to
highlight Time
Set. Press
OK/ZOOM to
select it.