Advertisement
KV-SSM100 /KV-SS1100 NETWORK SCANNER ADAPTER
QUICK SETUP GUIDE
6.
Enter Subpath (optional).
Note: Friendly Name and Subpath will display on screen in list of
shared folders.
7.
Under Security, select Use Authentication checkbox and Specify
credentials directly.
Enter Username and Password.
8.
9.
When finished, press [Add Share].
10.
Press [Next].
11.
Press [Skip] until main screen displays [Scan to Folder] button.
Note: Again, for instructions on setting up Scan to Email, Scan to
Fax, Scan to Bluetooth and Scan to Printer, please refer to the
KV-SSM100/KV-SS1100 Network Scanner Adaptor Administrator's Guide.
12.
Press [Yes] when asked, Are all settings and configurations
correct?
13.
Continue with Step 2....
STEP 2:
PERFORM SCAN
Once Initial Configuration is complete, perform a Scan to Folder
operation, as outlined below:
1.
Place document on scanner ADF.
2.
Press [Scan to Folder] button.
3.
Select desired shared folder.
4.
Use default Document Name or enter different name.
5.
If desired, create subfolder.
6.
Press [Continue].
Select desired Scan Settings.
7.
8.
Press [Scan].
Document is scanned and saved to selected folder.
9.
To scan again, place document on scanner ADF, and press [Scan].
10.
To exit, press [Cancel] > [Cancel].
©2017 Panasonic Corporation of North America. All rights reserved. KV-SSM100 / KV-SS1100 Quick Setup Guide_11/17
(CONTINUED)
MANUAL SETUP
Manual Setup of shared folders is required if:
You wish to add FTP network shares. FTP does not support
n
discovery, so you must enter the path for FTP network
shares manually.
Access to the computer is password-protected. You will
n
need to manually specify the username and password.
1.
Press [Add] to add a shared folder.
Note: If Network Discovery was unsuccessful,
press [
2.
Enter FTP address or UNC Path.
Note: Valid path names for network shares are:
FTP: ftp://MyServer/MyShare
n
UNC: \\MyServer\MyShare\
n
3.
Press [Configure].
4.
Enter Friendly Name (required).
5.
Enter Subpath (optional).
Note:
Friendly Name and Subpath will display on screen in
n
list of shares.
You cannot add two shares with the same name.
n
6.
Under Security, set Use Authentication. (See
Shared Folder Configuration [top left column].)
Press [Add Share].
7.
Share Management screen displays shared folder path.
Repeat 1-7 to add another shared folder.
8.
9.
When finished, press [Next].
10.
Press [Skip] until main screen displays [Scan to Folder]
button.
STEP
11.
Go to
Notes:
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
_________________________________________________
] to return to Add Share screen.
2.
us.panasonic.com/scanners
7
under
CONTACT US
1.877.201.0035
Advertisement
