Table of Contents
Advertisement
If you are running Service Pack 3, the following screen is displayed.
Figure 2.18
Wireless network properties
Place a check mark in the Connect even if that network is not broadcast-
ing box.
NOTE:
i
The SSID box is case-sensitive, so you must use all capital letters.
20
Type WVL2_A in the Network name (SSID) text box.
21
Be sure that Network Authentication is set to Open.
22
Be sure that Data encryption is set to disabled.
- Step 2: Configure the Wireless Network Card
Wireless Vehicle Link 2 Installation and Setup Manual 29
Advertisement
Table of Contents
