C—Data LED
Lights up yellow when the WVL2 receives data from the vehicle.
D—Wireless LED
Blinks yellow whenever the WVL2 is connected wirelessly. The LED blinks
faster for a strong connection, and slower for a weak connection.
E—Fault LED
Lights up red when a problem is detected.
With a wireless connection, the Fault LED and the Wireless LED work together
in the following way:
LED Behavior
Both LEDs off
Both LEDs blinking at a one
second rate
Both LEDs blinking alternately at a
one second rate.
F—USB Port
Connects the WVL2 to your PC/laptop.
NOTE:
i
For additional information on trouble shooting LED behavior, refer to
Chapter 5: WVL2 Troubleshooting Information, later in this manual.
Fault Condition
No access point or other ad hoc card
found
No SSID found
No IP address found
WVL2™ Installation and Setup Manual
- WVL2 Device
7