Panasonic SC-GA10 Owner's Manual page 19

Firmware updates
The following status indicators keep lighting
up in orange.
An error has occurred. Disconnect the AC
power supply cord from the AC outlet, reconnect
it to the AC outlet after about 30 seconds. The
unit will try to update again.
Network
Cannot connect to the network.
≥ Make sure that the multicast function on the
wireless router is enabled.
≥ This unit's Wi-Fi security does not support
WPA2-Enterprise. For details on the security
supported by your router and how to change the
settings, please refer to the Owner's Manual for
the router or contact your Internet service
provider.
Cannot select this unit as the output
speakers.
≥ Make sure that your devices are connected to
the same network as this unit.
≥ Reconnect your devices to the network.
≥ Turn off and then on the wireless router.
Playback does not start.
The sound is interrupted.
≥ If using the 2.4 GHz band on the wireless router,
simultaneous use with other 2.4 GHz devices,
such as microwaves, cordless telephones, etc.,
may result in connection interruptions. Increase
the distance between this unit and these
devices.
– If your wireless router supports 5 GHz band, try using
the 5 GHz band. To change to the 5 GHz band, redo
the network setup to select your network name for the
5 GHz band.
≥ Do not place this unit inside a metal cabinet, for
it might block the Wi-Fi signal.
≥ Place this unit closer to the wireless router.
≥ If several wireless devices are simultaneously
using the same network as this unit, try turning
off the other devices or reducing their network
usage.
≥ Reconnect the devices to the network.
≥ Turn off and then on the wireless router.
Error indications
The status indicators (l 7) show one of the
following blinking patterns in orange.
≥ There is a problem with this unit. Disconnect the
AC power supply cord from the AC outlet,
reconnect it to the AC outlet after about 30
seconds. If the problem still persists, disconnect
the AC power supply cord and consult your
dealer.
19
TQBJ2056