Instrument Control Using Hp Basic; Required Equipment - Agilent Technologies 8719ET Programmer's Manual

Network analyzer

Hide thumbs Also See for 8719ET:

Table of Contents

Instrument Control using HP BASIC

This section describes how to control the analyzer using HP BASIC 6.2 (or higher), or

HP BASIC for Windows 6.3 (or higher) on one of the following computers:

• HP 9000 Series 200/300

• HP 9000 Series 700 with HP BASIC-UX

• PC with a GPIB interface card installed

For more information on HP BASIC, see

General Purpose Interface Bus, see

Table 2-1 Additional BASIC 6.2 Programming Information

HP BASIC 6.2 Programming Guide

HP BASIC 6.2 Language Reference (2 Volumes)

Using HP BASIC for Instrument Control, Volume I

Using HP BASIC for Instrument Control, Volume II

HP BASIC for Windows Manual Set

Table 2-2 Additional GPIB Information

HP BASIC 6.2 Interface Reference

Tutorial Description of the General Purpose Interface Bus

• Computer running HP BASIC 6.2 (or higher) or HP BASIC for Windows 6.3 (or higher)

• Supported GPIB interface card

• GPIB interconnect cables (such as 10833A/B/C/D)

2-1. For more information concerning the

Introduction to Instrument Control

Instrument Control using HP BASIC

Show Quick Links

Table of Contents