Table of Contents
Advertisement
Questions and answers
If you have any queries about the use of your telephone, visit our website at
www.gigaset.com/service for 24-hour support. The table below contains a list of com-
mon problems and possible solutions.
Problem
Cause
Nothing
The handset is not switched
appears in
on.
the display.
The batteries are flat.
No wireless
The handset is outside the
connection
range of the base station.
to the base
The handset is not regis-
station,
tered.
Base flashes in
The base station is not
the display.
turned on.
You cannot
The phone cord supplied
hear a ringer/
has not been used or has
dialling tone
been replaced by a new cord
from the fixed
with the wrong jack connec-
line network.
tions.
Error tone
The system PIN you have
sounds after
entered is incorrect.
system PIN
prompt.
PIN forgotten.
!
Contact with liquid
If the device comes into contact with liquid:
1
Disconnect the power supply.
2
Remove the batteries and leave the battery compartment open.
3
Allow the liquid to drain from the device.
4
Pat all parts dry.
5
Place the device in a dry, warm place for at least 72 hours (not in a microwave,
oven etc.) with the battery compartment open and the keypad facing down (if ap-
plicable).
6
Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normaly be able to use it again.
Solution
a
Press the end call key
for approx.
5 seconds or place the handset in
the base station.
Charge or replace the batteries.
Move the handset closer to the base
station.
¢
Register the handset
page 7.
Check the mains connector on the
¢
base station
page 3.
Please always use the phone cord
supplied or ensure that the
pin connections are correct when
purchasing from a retailer: 3-4
assignment of telephone leads/
EURO CTR37.
Reset the system PIN to the default
¢
0000
page 8.
All handsets are de-registered. All
settings are reset. All lists are
deleted.
10
Advertisement
Table of Contents
