Activating/Deactivating The Handset - Gigaset A150 Manual

Hide thumbs Also See for A150:
Table of Contents

Advertisement

Please note
The handset is pre-registered with the base. If you have purchased a
model with multiple handsets, all handsets will already be registered
with the base. You do not need to register the handset again. The internal
handset number appears in the top left of the display, e.g. 1 (
However, if a handset is not registered with the base (Register HS or Put
into base is displayed), please register the handset manually (
If you have purchased multiple devices, you can upgrade your Gigaset to
a cordless PABX by registering all A150/A250 handsets at the same base
¢
(
page 7).
After the first battery charge and discharge, you may place your handset
in the charger after every call.
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
The batteries may warm up during charging. This is not dangerous.
After a while, the charge capacity of the batteries will decrease for techni-
cal reasons.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming
calls, and so that the alarm can be used.
¤ u
¤
¤
MENU
Settings
OK
Date/Time
¤
¤
and year in 6-digit format)
OK
Time
¤
format)
OK (display message: Saved)
¤ a
(press and hold to return to idle status)
¢
page 1).
¢
page 7).
~
¤
¤
¤
OK
Date
(enter the day, month
~
¤
(enter hours and minutes in 4-digit
4
When entering the time and date, you can move the position of an entry to the left or
right by pressing the control key
Please note
If your phone receives the date and time during calling line display (e.g., via your
network provider, a router or PABXs), you can specify whether this data should be
copied to your phone:
¤
Press the key sequence: MENU
The following is displayed;
the current setting flashes:
¤
Press one of the following keys to specify, when this data should be copied to
your phone:
Q
Never
1
or
Once, in case the date/time is not set on your phone
2
or
Always
Your selection is displayed (e.g. 2):
¤
Press the display key OK.

Activating/deactivating the handset

a
Press and hold the
key to activate or deactivate the handset. If you place a deacti-
vated handset in the base station or charging cradle, it will automatically activate after
approx. 30 seconds.
If you remove the handset from the base station/charging cradle, the display turns off
briefly.
u
up or down.
¤ P#Q5#MI
973 SET: [ 0 ]
973 SET: [2]

Advertisement

Table of Contents
loading

This manual is also suitable for:

A250

Table of Contents