Advertisement
'INSET' (REBATED)
-
STAGE 1 (Preparing the S-Box™)
Remove and discard the existing Steel top - by unscrewing its 3 dome nuts.
Loosen the 6 Collar screws and press it down - so that it is level with the pattress metal. (
P.S. The pattress is the flat skirt plate shown below.
This re-creates the clearance required below the later new top - so that when it is pressed down it will
engage and disengage the catch mechanism inside the unit. Re-tighten the collar screws (with the
new top temporarily ↓ in position) so that the required 20mm total is achieved (as below)
20mm
Note:
MAX THICKNESS OF ANY
CUSTOM TOP IS 12mm
*PLEASE NOTE*
THESE STAGE 1 INSTRUCTIONS ARE TO ENABLE THE
CONVERSION OF A UNIT THAT HAS A STEEL TOP AND
COLLAR ALREADY FITTED WHEN IT WAS DELIVERED.
IF YOU HAVE A UNIT THAT IS ALREADY PREPARED FOR A
CUSTOM TOP (i.e. S-BOX CHAMELEON) YOU MAY SKIP
TO STAGE 2.
>
<<
4-5 mm clearance
for 'press down' action
A PRE-PREPARED "CHAMELEON"
MODEL LOOKS LIKE THIS →
Both can be inserted into the 20mm rebate
and both are ready to receive the custom top
See below
YOUR "ADAPTED" UNIT WILL LOOK
LIKE THIS ↓
).
Advertisement
