Mounting The Bike Handle - Stihl FS 311 Instruction Manual

Mounting the Bike Handle

Hold the lower clamp (1) and upper
N
clamp (2) firmly together.
Release the clamp screw (3) – the
N
clamps are loose once the clamp
screw has been released. They are
pushed apart by the two
springs (4 and 5).
Pull out the clamp screw – the
N
washer (6) remains on the clamp
screw.
Separate the clamp moldings – the
N
springs (4 and 5) remain in the
lower clamp.
FS 311
A
4
1
Place the handlebar (4) in the lower
N
clamp (1) so that distance A is no
more than 15 cm (6 in).
Place the upper clamp (2) in
N
position and press it down.
Insert the clamp screw (3).
N
Line up the handlebar (4) at a right
N
angle to the drive tube.
Tighten down the clamp screw (3)
N
firmly.
8
7
5
6
Take out the screw (5), the nut (6)
N
remains in the control handle (7).
Push the control handle onto the
N
handlebar (4) until the holes (9) line
up – the throttle trigger (8) must
point towards the gearbox.
Insert the screw and tighten it down
N
firmly.
Go to "Adjusting the Throttle Cable".
N
Transport and storage position: Loosen
the clamp screw, turn the handlebar in
line with the drive tube and fold the
handles down.
English
7
9
4
9
19