12 ControlLogix EtherNet/IP Module
Make sure that the module backplane connector properly connects to
the chassis backplane.
The module is properly installed when it is flush with the power supply or
TIP
other installed modules.
Connect the Module to the EtherNet/IP Network
WARNING: If you connect or disconnect the communication cable
with power applied to this module or any device on the network,
an electrical arc can occur. This could cause an explosion in
hazardous location installations.
1. Be sure that power is removed or the area is nonhazardous before
proceeding.
2. Attach the RJ45 connector to the Ethernet port on the bottom of the
module as shown.
Rockwell Automation Publication 1756-IN603C-EN-P - April 2010