Remote Control; Cooler Location - Honeywell CS12AE User Manual

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
TIMER
Press the TIMER button until the indicator light moves to your desired time. When the set time has
passed, the unit will automatically turn off (unit remains in Standby mode until power cord is unplugged
from electrical socket). The TIMER function allows you to program the unit for up to 8 hours of use.
SWING
Press the SWING button until the indicator light is illuminated. The louvers will begin to move
left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical air flow.
MODE (COOL)
Press the MODE button to select COOL mode. Pressing the MODE button until COOL is
illuminated on the control panel activates evaporative cooling. The water pump will operate and you will
feel the cooler air after the Honeycomb Cooling Media is completely wet.
Pressing the MODE button until COOL is illuminated activates evaporative cooling.
Pressing the MODE button again will deactivate COOL light on the control panel, switching off
evaporative cooling.
Note: When the cooling function is switched OFF, the unit can still function in a fan only mode (without
evaporative cooling).

REMOTE CONTROL

ON/OFF
MODE
TIMER SWING
SPEED
Note:
• Open the battery compartment at the back of the remote control and insert a AAA (2 x 1.5V) battery
inside. Care must be taken to insert the batteries according to the correct polarity (+ / –) markings
shown inside the battery compartment.
• Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
• Remove the batteries if the unit is not going to be used for an extended period of time.
• Do not drop the remote control.
• Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
• Do not mix old and new batteries.
• Exhausted batteries are to be removed from the product.

COOLER LOCATION

Make sure to position the air cooler correctly before you set up and start using the product. Please refer
to the COOLER LOCATION (IMPORTANT TO READ) section of the separate Safety & Maintenance
Guide.
2
Power : ON / OFF
Speed : Low / Medium / High / Sleep
Mode : Evaporative Cooling On / Off
Swing : Controls the motion of the louvers
Timer : Controls timer function for automatic off
EN
SWING POWER
8H 1H
HIGH
SPEED 7H TIMER 2H
MID COOL
6H 3H
LOW SLEEP MODE 5H 4H
LOUVER
MOVEMENT