All Sett; Main Settings; Testing - LED Strip Studio LED Ethernet Controller 3 User Manual

ALL SETT.

Display all the settings of the LEC3 device. In case you want to display just some of Main, Autoplay, Art-Net or DMX
settings, just click some of the link in the main top menu. This is the list of all the sections with explanation.

MAIN SETTINGS

Contains basic settings of the LEC3 device.
Device name (max 18 chars)
Default IP
Mask
Max brightness (0-255)
Don't for get to press Save Main Sett. or Save name after you change some of the setting!

TESTING

This allows you to display several test patterns on your LEC3 SPI output. It's practical to e.g. set the order of the
RGB channels or type of the used LED strip (LED IC). Don't forget to press Stop Test after you finish to make sure,
the device will stop displaying test pattern!
You can set device name for better orientation in case you use multiple LEC3
devices in your installation. You have to press Save name to save the setting after
you change it.
In case the DIP switch is set to 0, this is the device IP address, which will be used
in Local Area Network.
IP Address mask can be set here.
Maximal brightness of all output for all modes. This is practical in case you want
to save your LED life by lowering maximal brightness for the users.