Connecting Tm, Ws, Apa Or Sk Family Led Strips With Lec3; Direct Connection - LED Strip Studio LED Ethernet Controller 3 User Manual

CONNECTING TM, WS, APA OR SK FAMILY LED STRIPS WITH LEC3

DIRECT CONNECTION

Following scheme shows how to connect SPI digital LEDs (TM, WS or SK family digital LEDs), power source and
LSS3:
Power source, TM/WS/SK LED strips and LEC3 board connection scheme
You can use 5-24V power supply depending on used digital strips or pixels. The power source can be connected
directly to LEC3. The SPI outputs are powered and LEC3 can handle up to 5A output power per output (thus you
can use up to 20A power source).
In case you use more power than 5A per output, LEC3 contains polyfuse (a.k.a. polyswitch or resettable fuse),
which will prevent destruction and lower the power (you'll see, the brightness of your LEDs will be lower).