Table of Contents
Advertisement
.
Head Assembly
CAUTION: Wear thick, protective gloves or other protective covering while handling front lens. The
lens is extremely fragile and can break if too much force is applied. If dirty, clean with isopropyl
alcohol and a soft, lint-free cloth.
Step 8. Install front lens as follows:
a. Any lens must be installed CONVEX (bubble side out, away from luminaire head
Note: Front lens ring assembly contains a rubber gasket. Be sure gasket is properly seated in front
ring before installing lens and is not damaged in next step.
b. Carefully press rear side of lens towards front ring with fingers until glass is securely in
Step 9. Clean front and rear of lens (if required).
Step 10. Close front ring assembly and latch. Luminaire is ready for use.
02.96 83.000 1 0
Pivot / Hinge Screws
(see detail)
Figure A-5: VL550CD Front Lens Assembly Installation
assembly).
place.
Figure A-6: Front Lens Installation
16 No vemb er 2010
T
ROUBLESHOOTING AND
b
a
Front Ring
Assembly
M
AINTENANCE
Detail
Note, bottom of
pivot/hinge screw
goes into top screw
when installed in
hinge.
Front Lens
Front Ring
Assembly
A
63
Advertisement
Table of Contents
