Advertisement
Start the Operations Console configuration wizard on the system console.
7.6
1.
Click
Start > Programs > iSeries Access for Windows > Operations Console
Follow the steps in the wizard. Use the following information to enter any required data.
2.
Service host name
(interface name):
Target partition:
Serial Number:
Service tools device ID:
Access password:
3.
Click
Finish
Right-click the connection name and select
7.7
console will not complete the connection until you have completed step 7 . 1 0.
Connect your server to a power source. The control panel should be lit and display
7.8
N V=F
. The server is not yet powered on.
01 B N V=F
Note:
If
Information Center. For details about how to access the information center, see task 11
Finish your system setup
Press the white Power On button on the front of the server. There is a short delay before
7.9
the server powers on, of approximately 5 to 20 minutes. When the server powers on, the
control panel displays
When the LAN Service Tools Sign-on window is displayed, type your access password,
7.10
and then type
You have completed the basic setup. Go to task 11
Use either the name of a current network interface, or a new
name for this connection.
Enter the number , even if you are not partitioning.
Enter the serial number located on the server control panel.
Use the default value
Enter a password that you will remember. The password is case
sensitive and can be a maximum of 128 characters.
to save the configuration and to exit the configuration wizard.
does not display, see the instructions in the IBM Systems Hardware
.
01 B N V=F
11111111
(eight 1's) in both the service tools user ID and password fields.
1
QCONSOLE
Connect
to start your connection. The system
.
Finish your system setup
.
.
01 B
.
Advertisement
