Table of Contents
Advertisement
K. Ember/Mineral Wool Placement
WARNING! Risk of Explosion! DO NOT place embers
directly over burner ports. Improperly placed embers inter-
fere with proper burner operation. See instructions.
Ember material is shipped with this gas appliance. To place
the ember material:
• Place dime-size pieces of Glowing Embers® just in
front of the port trail, but not on or in between the ports
See Figure 11.23. Embers are to be placed adjacent
to burner port holes. Care should be taken so that the
ports are not covered. Failure to follow this procedure
will likely cause lighting and sooting problems.
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
NO EMBERS IN THIS AREA
Figure 11.23 Ember Placement
L. Install Outer Refractory Panels
1. Install glass assembly. Refer to Section 11.A for glass
installation.
2. The refractory brackets are shipped wire-tied to the
right side support opposite the valve. See Figure 11.24.
Bend the back support of the refractory tab down. See
Figure 11.25. Install the two refractory brackets to the
glass frame and secure, but do not tighten. One screw
per bracket is required. See Figure 11.26.
3. Install both outer refractory panels and install refrac-
tory bracket to secure refractory panels in place. See
Figure 11.26.
4. Install Outer Hearth. See Figure 11.27.
Figure 11.24 Shipping Location of Refractory Brackets
48
Heat & Glo • ESC-42ST-IFT Installation Manual • 2464-980 Rev. C • 7/17
BACK SUPPORT
TAB
Figure 11.25 Back Support Tab Bent Into Position
Figure 11.26 Side Refractory Brackets
Figure 11.27 Outer Hearth Installation
M. Install Trim and/or Surround
• Install optional trim kits and/or surrounds using the
instructions included with the accessory.
• Use non-combustible materials to cover the gap between
the sheet rock and the appliance (if desired).
Advertisement
Table of Contents
