Table of Contents
Advertisement
1
Figure 6.
LOG NUMBER 2 (SRV2146-702):
grate bar. Pull log forward so it engages the far right grate tine as shown in Figure 6. The "burnt" end of the log rests on the
burner. The log must NOT block any burner ports.
1
Figure 8.
LOG NUMBER 3 (SRV2146-703):
back so that it rests against grate tine as shown in Figure 9. The "burnt" end of the log rests on the burner. The log must
NOT block any burner ports.
4
1
Figure 10.
LOG NUMBER 4 (SRV2146-704):
Figure 10. Push log so that it rests against the grate tine shown in Figure 11. The "burnt" end of the log rests on the burner.
The log must NOT block any burner ports.
46
GRATE
BAR
2
Place Log #2 as shown. The groove on the bottom of Log #2 engages with the
3
2
Place Log #3 so that groove on bottom of log engages the grate bar. Push log
3
2
Place Log #4 so that the groove on bottom of log rests on the grate bar as show in
Heat & Glo • ESC-42ST-IFT Installation Manual • 2464-980 Rev. C • 7/17
2
Figure 7. Reverse View
2
3
GRATE
TINE
Figure 9. Reverse View
2
3
GRATE
TINE
Figure 11. Reverse View
1
1
1
4
Advertisement
Table of Contents
