Table of Contents
Advertisement
F. Install Light Bulbs
Note: Light bulbs are shipped in the installation manual bag.
Ember Lights
1. Remove ember basket by lifting it from fireplace.
There is one metal tab on each end of the ember box
that engages slots in the ember basket. See Figure
11.9.
Figure 11.9 Ember Basket
2. Install two 20 watt halogen bulbs per side. See Figure
11.10.
NOTICE: Grip bulb by the porcelain base only. DO NOT
TOUCH glass bulb. Touching the bulbs with fingers will
greatly reduce the operating life of these bulbs.
Figure 11.10 Ember Light Bulb Installed
3. Reinstall ember basket over the ember box by inserting
the tabs on the ember box in the slots on the ember
basket. See Figure 11.9.
Accent Lights
1. Remove the screw that secures the two bottom sheet
metal refractory standoffs that are installed around
the left and right accent light assemblies. See Figure
11.13.
42
Heat & Glo • ESC-42ST-IFT Installation Manual • 2464-980 Rev. C • 7/17
2. Install the two accent lights by removing (2) screws
that hold the light housing to the firebox bottom. Install
bulb by inserting the 2 pins on the bulb base into the
2 holes in the socket. See Figure 11.11 and Figure
11.12.
SCREWS
Figure 11.11 Light Housing Removal
Figure 11.12 Light Housing Removed, Bulb Installed
3. Reinstall accent light cover to light socket assembly
and install with two screws to firebox bottom.
4. Reinstall the two bottom sheet metal refractory stand-
offs with one screw each. See Figure 11.13.
Figure 11.13 Accent Light Bulb Installation Completed
SHEET METAL
REFRACTORY STANDOFF
Advertisement
Table of Contents
