Advertisement
How to designate Telephone Numbers to TRIG 1 and TRIG 2 – Section 6 :
Quick guide: Press 1 2 3 4 > PROGRAM > 6 > ENTER > X > ENTER > N > ENTER
1) Key in the four digit user PASSWORD code (factory default 1234)
2) Press PROGRAM > 6 > ENTER.
Press 1 (for TRIG 1), or press 2 (for TRIG 2). Press ENTER
3)
4) You will now see numbers 123456789 illuminated. This indicates that all 9 telephone numbers (or as many as
have been programmed into the dialer) will be called on that trigger.
5) Press 1 - 9 to de-select that phone number from being dialed. You will now see a blank "-" where that number
was previously. Press ENTER to save the setting.
5) Repeat the process until you have designated all the numbers to each trigger. Remember that you can
designate all 9 numbers to each trigger or only some to one and some to the other.
IMPORTANT : The numbers shown on the LCD display are the phone numbers assigned to that trigger. Pressing
buttons 1 to 9 will toggle the numbers on/off on 1-9 respectively. If a number is not shown, then it means that it
will not be called.
Example: 123—67-9 means that telephone numbers 1,2,3,6,7 and 9 only will be dialed for that particular trigger.
Other Programming Sections
How to Program the Auto Dialer to give a local Audible Alarm as well as sending a voice message –
Section 1: (Default setting is alarm OFF)
Quick guide: Press1 2 3 4 > PROGRAM > 1 > ENTER > 1 > ENTER
1) Key in the four digit user <PASSWORD> code. (Factory default 1234)
2) Press PROGRAM > 1 > ENTER > 1 > ENTER
(Please note 0 = without Audible Alarm, 1 = with Audible Alarm)
How to Set the Time the Audible local Alarm will sound on activation – Section 2 : (Default time is 3 mins)
Quick guide: Press 1 2 3 4 > PROGRAM > 2 > ENTER > Time > ENTER (Alarm sound time is from 1M-99M.)
1) Key in the four digit user <PASSWORD> code. (Factory default 1234).
2) Press PROGRAM > 2 > ENTER > Time > ENTER.
TIME = <1> = 1 min, <99> = 99 min (max TIME 99 min). We recommend you do not exceed a 20 min
Alarm duration.
How to set Trigger Delay Delay times: (Default is 0 seconds - instant) – Section 4
Set trigger delay time between 0, 30 and 60 seconds: As a false alarm prevention feature, this is the delay
between a trigger being activated and when the dialer starts to dial out. Default setting is 0 secs.
Quick guide: Press 1 2 3 4 > PROGRAM > 4 > ENTER > N > ENTER
1. Key in the four digit user Password code (factory default 1234)
2. Press PROGRAM > 4 > ENTER > N > ENTER.
(Note: N=0, instant; N=3, 30 sec; N=6, 60 sec.)
Advertisement
