Advertisement
How to install the Auto Dialer
1.
Remove the small screw from the battery compartment cover and keep safe.
2.
Mark and drill two holes on a horizontal line 160 mm apart.
3.
Insert the masonry plugs; screw the two fixing screws in the plugs leaving 2 mm protruding.
4.
Run a cable from the Alarm Control Panel to the Auto Dialer.
5.
Trigger 1 = alarm switched neg. and anti-tamper, switched neg.
6.
Trigger 2 = alarm switched neg.
7.
Tamp = Connect to N.C. (normally closed) tamper inputs of the Alarm Control Panel
8.
Connect phone line from the LINE on the Auto Dialer to an existing Phone Socket, if this is in use you will
have to purchase a double adaptor. If you want to plug into an existing Telephone you will have to purchase
an RJ11 to RJ11 cable, connect one end into PHONE on the back of the Auto Dialer and the other into the
Telephone.
9.
Install 1 x 9V back up battery (if required) to the terminals, making sure they are the correct polarity. Usually,
back up power would be supplied from the alarm panel battery to which the dialer is connected.
10.
The auto Dialer will beep once.
11.
Replace the battery compartment cover.
12.
Connect the 12V power supply.
13.
Place the Auto Dialer onto the wall, making sure the tamper switch is pressed in.
14.
You can now start to program the Auto Dialer
How to make the Connections on the Auto Dialer.
The Trigger terminals are for connection to a switched negative output of an Alarm System's
Bell or Siren (Fig 1 below). If such switched negative triggers are not available, connect the
trigger inputs to a N.O. (normally open) relay output with the relay common to OV (Fig 2).
The Power terminals are for connection to a 12V power supply, either directly to an Alarm
Control Panel's 12V supply or else via a 500mA mains power adaptor.
The Tamper terminals are for connection to the N.C. (normally closed) tamper inputs on an
Alarm Control Panel. If they are not being used, please fit a loop of cable as shown
Fig 1
TAMP
TR2
TR1
0V
12V+
swt – (bell/siren switched negative, this unit will not operate off a switched ground)
swt -
Installation
LINE
PHONE
12V 500mA Input
Advertisement
