Advertisement
ASSEMBLY
STEP 1 – HANDLES
Remove the contents from the carton and
ensure you have all the below listed
components:
Spark Plug Spanner x1, Instruction Manual x1,
Multi-Spanner x1, Cable Ties x2, Upper Handle
Wing Nut & Bolts x2, Lower Handle Nuts &
Bolts x2, Recoil Starter Guide x1, Mulch Plug x1
(this may be fitted to the machine for transit
purposes), Side discharge cover.
Place the lower handles onto
the deck and secure by
inserting the lower bolts &
nuts. Tighten until secure.
Pair the upper handle to the
lower handle.
Starting on the right side,
place a bolt through the recoil
starter guide, lower & upper
handles and secure with a
wing nut until tight.
Repeat on the left side.
Secure the OPC/Brake & Drive
cables to the upper and lower
handles, using the cable ties
supplied.
Hold the OPC/Brake lever up
to the upper handle. Slowly
raise the recoil starter up to
the guide and house.
Advertisement
