Ricoh Aficio 1060 General Settings Manual page 51

C C C C
Press the [Interface Settings] key.
D D D D
Make the [Effective Protocol] settings.
Note
❒ You must configure IP address for using TCP/IP protocol. Consult the net-
work administrator for help with the address. You don't have to configure
it if Network Boot is DHCP.
❒ Press the [Invalid] key for redundant protocols.
❒ Press the [Effective] key for TCP/IP protocol when you use pure IP of Net-
Ware 5/5.1.
A Make sure that the [Network] key is selected, and then press the [Effective
Protocol] key.
B Press the [Effective] or [Invalid] key for each protocol.
C Press the [OK] key.
The following operation will be different, according to each protocol.
When using TCP/IP
A Make sure that the [Network] key is selected, and then press the [IP Ad-
dress] key.
B Use the number keys to enter the IP address.
Note
❒ Press the [← ← ← ← ] or [→ → → → ] key to move in 3-digit increments.
❒ Press the [Clear] key if the wrong address is entered.
C Press the [OK] key.
D Make the [Sub-net Mask] and [Gateway Address] settings. For each item,
press the corresponding button on the screen shown in step A A A A , and then
perform the same procedure as described in steps B B B B and C C C C .
Configuring the Network
2
37