Dismounting The Loader - RHINO F-4243C Operator's Manual

5. On level ground, tilt the attachment down 90 degrees
and lower it to the ground. Lower the loader further to
slightly raise the front of the tractor of the tractor off
the ground. Drive the tractor in reverse while the
attachment is on the ground for 20-30 feet to insure
the attachment does
attachment disconnects
discontinue the use of attachment and contact your
dealer.

Dismounting the Loader

1. Locate tractor and loader on firm level ground.
2. With bucket raised above ground, tilt bucket
down approximately 30 degrees from level.
3. Lower boom by retracting lift cylinders to lift
tractor front end (tires can be off ground).
4. Stop Engine. Allow tractor front end to lower by
relaxing ONLY lift cylinders with control lever.
This will remove pressure on hitch pins (See
Figure Asm-L-0002).
NOTE: Do not relax bucket Cylinders.
5. Set parking brake. Rotate parking stands from
storage position by removing lynch pins and
clevis pins. Reinstall clevis pins and lynch pins
when parking stands are in operation position
(See Figure Asm-L-0001).
6. Remove lynch pins and 1" hitch pins from
loader upright.
7. Start tractor engine and release brakes. Retract
bucket cylinders to allow parking stands to
contact ground.
It is important not to put excessive weight on parking stands with lift cylinder retraction.
Damage may result..
1625 01/11
© 2011 Alamo Group Inc.
ASSEMBLY
not disconnect. If the
during this process,
Assembly Section 3-18