Table of Contents
Advertisement
Pre-Operation Check
1. Adjust front wheel tread setting stops, if necessary, to provide a minimum 3/4" clearance between front
tires and any part of the loader with lift cylinders fully oscillated. Be sure lift cylinders are fully retracted.
Refer to Preparing Tractor (page 3-5). Refer to tractor operator's manual for tread setting and steering
stop adjustment procedures.
2. Lubricate all grease fittings with SAE multipurpose grease.
3. Check hydraulic fluid level in tractor. Fill to recommended level, using oil specified in tractor operator's
manual.
1625 01/11
© 2011 Alamo Group Inc.
ASSEMBLY
Figure 3:
Coupler and Bucket
Assembly Section 3-14
Advertisement
Table of Contents
