Tractor And Loader General Information - RHINO F-4243C Operator's Manual

Tractor and Loader General Information

Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
Never allow anyone to get under the loader or attachment or to reach
through the loader lift arms when raised. Serious injury could result from
crushing or pinching by the loader or attachment.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never interfere with factory-set hydraulic calibrations.
cause a failure of the equipment and may result in injury.
Mounting kit can be installed using tools ordinarily available, including a hoist capable of lifting and supporting
the loader for initial mounting, standard and metric wrenches, torque wrench, and hydraulic oil.
Tractor-supplied hydraulic power is required for loader mounting and operation.
The grille guard (9) may be installed with or without the loader.
Check tractor tire pressure. Refer to tractor operator's manual for recommended pressures. With tractor on a
firm level surface, compare tractor rear axle height from left to right, measuring from axle center to ground.
Adjust air pressure in rear tires until axle height measures same for both sides.
NOTE: If rear axle on tractor is not level from side to side, cutting edge on loader bucket or similar loader-
mounted attachments will not sit flat on ground.
Set the tractor's front tread width to 1280MM (50.4") on a 2WD machine; 4WD tractors are not adjustable. For
better stability, set the rear tread to 1375MM (54.1") or wider.
Tractor steering stops may have to be adjusted to provide clearance between front tire and loader on a full left
and right turn with front axle fully oscillated. Be sure lift cylinders are fully retracted when checking tire
clearances. Refer to tractor operator's manual for steering stop adjustment.
NOTE: Reference to left and right used in these instructions refer to position when seated in the operating
position on tractor.
1625 01/11
© 2011 Alamo Group Inc.
ASSEMBLY
(SG-14)
Do not permit anyone to modify or alter this
Assembly Section 3-5
(SL-06)
(SG-8)
Any change in calibration could
(SBH-13)