Advertisement
Programme Chart and Quick Reference Card
Loading the dishwasher
There are three separate baskets, in which you can put your dinnerware, in your machine.
The shelves on the rack are made adjustable to accommodate tall pieces.
Folding Plate Support Rods
There are four separate "folding plate support rods" in the lower basket of your dishwasher
designed to allow you more space to accommodate saucepans and large bowls in the lower
basket. You can either fold each section (1,2,3,4) individually or, all at once, to create a large
empty space. Simply press the handgrips (A) and fold them down"
A
Long cutlery, such as ladles and long knives, etc must be placed horizontally on top of the full cutlery
basket or on the racks to prevent accidental injury.
Place spoons and forks in the cutlery basket with handles down and knives with handles up to
prevent accidental injury.
Upper Basket Height Adjustment
The default position of the upper basket
of your machine is adjusted at the higher
position. According to the size of the dishes
you can change the position of the upper
basket. To do this, Release the latches
on both the right and left tracks by turning
them sideways. Remove the basket.
Change the position of the rollers and
place the basket back on the track then
shut the latches.
(If applicable)
(if provided)
Programme Chart and Quick Reference Card
GB
THE ACROBAT SYSTEM (If provided)
The upper basket is designed with a built in
elevator system which allows you to move
the upper basket up or down even when its
fully loaded, without having to take it out of
the machine. 1
The upper basket is set at the "low" position
at production. To bring the upper basket to
the "high" position,hold from the side one of
the upper basket and gently pull upwards.
To raise the other end of the basket hold from the other side and do the same 2. To lower the upper
basket, hold from the lever on one side of the basket and gently lower the basket without removing
your hand from the lever 2. Do the same holding the lever on the other side of the basket. Always
ensure both sides of the elevator mechanism are level.
Three-way split cutlery basket
Depending on the amount of load and load type, three-way split cutlery basket can be split into three
parts. Part B and/or part C can be placed in the upper basket.
To dismantle the three-way split cutlery basket follow the below instructions and see the diagrams
supplied.
Rotate handgrip which is at the bottom of handle.
Remove top and bottom hangers by sliding each part in opposite direction.
If you want to reassemble the cutlery basket, the reverse of the above operations should be carried
out.
Part A can not be placed into the upper basket.
Long cutlery, such as ladles and carving knives, should not be placed in the upper basket parts B
or C. They can be placed on the side racks on the upper basket.
In order to obtain the best cleaning and drying performance in cutlery basket, use the separators
of parts A, B and C.
To remove the separators follow the below instructions
For Part A ; Press from the sides and the separators can be removed easily
For Parts B and C; Press from the sides where handle is placed and the separators can be removed
easily.
B
B
A
A
C
C
(if provided)
A
GB
Advertisement
