Cashinotech KP628C Manual page 20

KP628C Kiosk thermal printer control board user manual
range m = 0、1、32、33
1 ≤ Hl + Hh × 256 ≤ 384
0 ≤ d ≤ 255
k = Hl + Hh × 256（when m = 0、1）
k = ( Hl + Hh × 256 ) × 3（when m = 32、33）
XX80：
m = 0、1、32、33
1 ≤ Hl + Hh × 256 ≤ 576
0 ≤ d ≤ 255
k = Hl + Hh × 256（when m = 0、1）
k = ( Hl + Hh × 256 ) × 3（when m = 32、33）
Default No
Support types All
[d]k corresponding bit is 1,which means this bit can print.While it is 0,it means
this bit can not print.
The printing area parts of exceeding graphics horizontal direction will be
ignored.
Bit map data and printing effects relations is as below:
Notes
The command is only filled printing buffer,graphics printing can start only
after receiving printing commands.Printing buffer will clear after graphic
printing.
If you need to print big graphics,you can divide it into several pieces 8 （m =
0、1）or 24（m = 32、33）dots graphics to print.
After filling graphic data,you can continue to fill other information to make
graphic and other information to print simultaneously.
After filling bitmap,you can use ESC J(n=24)command to print,and also
can use LF command to print.But LF command will make paper feed
operation(according to line space to feed paper),and make graphic continuously
between different lines.And can set line space to 0 to avoid to feed too much
paper.(Dot matrix printer may drift when it starts,pls send data continuously if it
breaks line.
1B 40
Example 1b 2a 00 0C 00 FF FF FF FF FF FF FF FF FF FF FF FF
1B 33 00
20 Page of 38
CASHINO TECH