Pioneer XV-DV575 Service Manual page 43

5
ID DATA Input Mode
NOTE: Be sure to use a specified DVD (ID) DATA DISC.
To enter ID DATA Input Mode, with the ID number set, press the
1
ESC key then the STEREO key.
2 When the STEREO key is pressed, the unit enters ID DATA
Input Mode.
[Player's ID Number Setting]
ID Number ?
[ 0 0 0 0 0 0 0 0 1 ]
Compare
> ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
<CLEAR> Exit
<STEREO> ID Data Setting Mode
2
Input ID Number !
3 If the DVD DATA DISC is loaded in this mode, the unit
automatically starts reading the data.
(If the DVD DATA DISC has already been loaded, the unit does
not start reading the data. In this case, open then close the
tray.)
4 To exit this mode, press the CLEAR key. While data are being
read from the DVD DATA DISC, you cannot exit this mode.
[Player's Data Input Mode]
<CLEAR> Exit
4
Insert The ID Data Disc !
5
6
When writing of the data read from the disc to flash ROM is
5
completed, "Rom Write OK!" is displayed. After seeing this
message, you can exit this mode by pressing the CLEAR key.
Note: Whether or not the data have been written to flash ROM can
be confirmed by watching for the message "Rom Write OK!"
being displayed after the disc is read.
[Player's Data Input Mode]
5
6 If the data cannot be read from the disc, the unit will be exited
ID Data Input Mode and proceed to the display of "Pioneer"
logo.
• Indication when the data have not been set
If no ID data are set after the ID number is changed, the message
"NO DATA" flashes on the screen and FL display for a few seconds
after the power is turned on or during Stop mode.
XV-DV575
6
7
Rom Write OK!
<CLEAR> Exit
7
8
A
B
C
D
E
F
43
8