Pioneer XV-DV575 Service Manual page 39

5
NOTE
1. In case of the Clamper Assy installation, install correctly
as Fig. 5-B.
Plate Clamper
Clamper
6: HOLDER TRAVERSE/INSULATOR (F)/INSULATOR (R)
(Refer to Fig. 6-A)
1. Remove the Holder Traverse.
2. Remove the 2 Insulator (F).
3. Remove the Insulator (R).
TRAVERSE Assy
Insulator (F)
Holder Traverse
NOTE
1. In case of the Insulator (F) installation, install correctly
as Fig. 6-B.
Insulator (F)
7: SW PCB ASSY/GEAR MIDDLE/GEAR FEED/
RACK FEED ASSY/FEED MOTOR
(Refer to Fig. 7-A)
1. Unlock the support 1.
2. Remove the Gear Middle.
3. Remove the screw 2.
4. Remove the Rack Feed Assy.
5. Remove the screw 3.
6. Remove the SW PCB Assy.
7. Remove the screw 4.
8. Remove the Gear Feed.
9. Remove the 2 screws 5.
10. Remove the Feed Motor.
11. Remove the Gear Motor.
5
6
Check Lock
Fig. 5-B
Pickup lens
GEM1004
Insulator (R)
GED-008
Insulator (F)
Fig. 6-A
Traverse Holder
Fig. 6-B
XV-DV575
6
7
Gear Motor
TRAVERSE Assy
Rack Feed Assy
2
3
• Screw Torque: 1.3 ± 0.3 kgf•cm (Screw 2)
• Screw Torque: 3.0 ± 0.3 kgf•cm (Screw 3)
• Screw Torque: 1.0 ± 0.3 kgf•cm (Screw 4, 5)
NOTE
1. When installing the Rack Feed Assy, push both ends to
align the teeth as shown Fig. 7-B. Then install it.
2. In case of the Gear Motor installation, check if the value
of the Fig. 7-C is correct.
3. When installing the wire of the SW PCB Assy, install it
correctly as Fig. 7-D.
Manual soldering conditions
• Soldering temperature: 320 ± 20 °C
• Soldering time: Within 3 seconds
• Soldering combination: Sn - 3.0 Ag - 0.5 Cu
4. After the assembly of the TRAVERSE Assy, hook the
wire on the TRAVERSE Assy as shown Fig. 7-E.
Rack Feed Assy
Push
[OK]
Gear Motor
Feed Motor
Safety surface for pressing
of the insert.
7
8
Feed Motor
1
5
5
Gear Feed
4
Gear Middle
SW PCB Assy
Fig. 7-A
Push
[NG]
Fig. 7-B
8.0 ± 0.2 mm
Fig. 7-C
39
8
A
B
C
D
E
F