Samsung HG40AC670 Quick Setup Manual

Quick Setup Guide
To register this product please visit
www.samsung.com/register.
-05
(For India Only)
This product is RoHS compliant.
For more information on safe disposal and recycling visit
our website www.samsung.com/in or contact our Helpline numbers -
18002668282, 180030008282.
List of Parts
➣ The provided accessories may vary depending on the model.
1 2 3
7
5 6
1 Remote Control 2 Power Cord
& Batteries (AAA x 2)
DATA Cable • Warranty Card (Except Hong Kong)
3 4
• Safety Guide
• Quick Setup Guide
5 Screws 6 Holder-Wire Stand
Hotel Mount Kit
7
Connecting the TV with an SBB or STB
➣ Depending on Model and Region.
Data Cable DATA
ETH MODEM
AV IN AV IN
HP-ID HP-ID
DOOR-EYE DOOR-EYE RJP RJP
1. Connect the [DATA] jack of the TV to the [ETH MODEM] jack of the STB (SBB) with the
Data cable.
➣ Use data communication.
List of Vendors and Compatible Data Cables Supplied with the TV
♦ Refer to the code label on the data cables.
Note the
Confirm the code on labeled end.
Note the
the Code Label
labeled end.
HC670_ASIA_QSG_BN68-05850G-05_ENG_161124.0.indd 1
Installing the LED TV Stand
♦ HG32AC670/HG40AC670/HG48AC670
Components
When installing the stand, use the provided components and parts.
➣ Depending on the model.
or
A B
1
C
Top View
B
x4 (M4 X L12)
A
Front
ATTENTION
Rear
DO NOT USE DO NOT
DO NOT USE
CHEMICALS GREASE USE OIL
4
2 3
✎ Place a soft cloth
O
over a table to
protect the TV, and
O O O O O O O O
then place the TV
on the cloth screen
side down.
✎ Insert the Stand
Guide into the slot
on the bottom of
the TV.
4
x4 (M4 X L12)
HG32AC670
Connecting through the Variable Output
PC / DVI PC / DVI
AUDIO IN AUDIO IN
PC IN PC IN
VARIABLE VARIABLE
AUDIO OUT AUDIO OUT
VOL-CTRL VOL-CTRL
5
HG40AC670
x4 (M4 X L12)
HG48AC670
C
Assembling the swivel
(M4 X L12)
You can set these stands so that the TV swivels 20 degrees left and right, 60 degrees left
and right or 90 degrees left and right.
If you assemble the wedge at the bottom of the
stand with the hole of the BRACKET HOLDER
20° Swivel
SWIVEL where either 20° to the left and right
respectively.
If you assemble the wedge at the bottom of the
stand with the hole of the BRACKET HOLDER
60° Swivel
SWIVEL where either 60° to the left and right
respectively.
If you only assemble the screws after you remove
90° Swivel the BRACKET HOLDER SWIVEL, the swivel
angle is 90° to the left and right.
X
X X X
X X X ♦ Hotel Mount Kit
Short Bolt (2EA) Long Bolt (2EA) Nut (2EA)
Top
[ Affix the stand to a flat surface such as
a dresser top, desk top, or entertainment
Bottom
center as shown.
x3 (M4 X L12)
[ WARNING: To prevent injury, you must attach this TV securely to the floor, a table,
a dresser top, etc. with the Hotel Mount Kit as described in these instructions.
Hospitality Plug & Play
Hotel Plug & Play is a function that automatically performs the Hotel mode selection, Local Set and Picture mode Setup once.
– Hotel Plug & Play is available only one time when power is first turned ON.
– This is available after first setting up the TV and transferring Clone TV data to a USB drive.
– To use Next TV, you only need to exit Hotel Plug & Play, connect the USB, then Clone the USB to TV.
– Depending on model and region, some menus may not exist.
♦ UI Scenario
Local Set
Change Local Set if Located in North America, Latin America and Europe.
If Skip is
In other regions, Please press SKIP button move to the next step.
selected
Current Localset : AD_AU_NZ2
Change Skip
If Standalone
E
Welcome to Samsung TV
Setup is selected
Select your language to start the on screen setup.
English
c
Press the udlr
简体中文 buttons to move the
highlight.
Press the enter button
to select.
Français
Italiano
The Language Setting will be applied to Main Menu and not Plug and Play.
Select Language
(Hong Kong only have "English 繁體
中文 简体中文")
Configure your TV
Set your information in the categories below. Select a picture mode
Picture Mode Standard
that best suits your
viewing environment.
Country Australia
To receive channels, configure the options below
then select Scan.
Aerial
Channel Type
Set Country and Picture Mode
(Hong Kong no have Country option)
Viewing the Connection Panel
x4
(M4 X L12)
1
DATA
PC / DVI
2 AUDIO IN
CLOCK
3
PC IN
AV IN
4
VARIABLE
HP-ID AUDIO OUT
5
RJP VOL-CTRL
6
1
DATA
PC / DVI
AUDIO IN
3
PC IN
AV IN
4
VARIABLE
HP-ID AUDIO OUT
Bolt + Nut
VOL-CTRL
DOOR-EYE RJP
$ 5 6
Washer (2EA)
➣ The product may vary depending on the model.
DATA
1
CLOCK
2
HEADPHONE JACK
3
HP-ID
4
RJP
5
AV IN
6
PC / DVI AUDIO IN
7
If Standalone Only is
selected:
Easy Set Up
TV will enter the
Standalone mode has
RF mode.
been set.
If you select this, the
setup process will be
Interactive completed and go to
c hotel menu. MAIN : Option, MODE : DTV, RES : NOTSUPPORT, Standalone Menu
(Hotel Menu)
Hospitality Mode Standalone
SI Vendor OFF
Standalone Setup
Power On
(Continue Setup) Channel
Menu OSD
Standalone Only
Clock
Hong Kong only have
Music Mode
(End Setup)
"Door Eye",others None Remote Jack Pack
External Source
and Hong Kong not have
Bathroom Speaker
Eco Solution
"security".
Logo/Message
Cloning
REACH Solution
Security
When complete, Power down TV.
TV Setup Complete!
Your TV is now ready to use.
OK
Auto Tuning Auto Tuning
Auto Tuning is finding channels for you...
Select the connected
aerial that you want to
Channel 27
use to get channels.
7%
Air
Digital 0
• TV 0
Digital & Analogue
• Radio 0
• Data/Other 0
Analogue 0
Scan Stop
- SIDE -
!
7
HDMI IN 2
(DVI)
HG**AC670
HDMI IN 1
(Except Hong
(ARC)
8
Kong)
@
(5V 0.5A) /
CLONING
9
0
#
ANT IN
- SIDE -
!
7 HDMI IN 2
(DVI)
HG**AC670
HDMI IN 1
(ARC)
(Hong Kong)
8
@
(5V 0.5A) /
CLONING
9
0
#
ANT IN
PC IN
8
VARIABLE AUDIO OUT
9
VOL-CTRL
0
HDMI IN 1(ARC), 2(DVI)
!
USB (5V 0.5A) / CLONING
@
ANT IN
#
DOOR EYE
$
System
Power off
Clock
You can adjust your time to set DST, Time Zone and
Set current date and time
clock mode
Clock Mode Auto
Date -- / -- / ----
Time -- : -- --
-- : -- --
-- : -- --
Set Clock
Auto Tuning
Auto Tuning completed.
Digital 0
• TV 0
• Radio 0
• Data/Other 0
Analogue 0
change settings Scan Again
2016-11-24 오후 4:13:31