Download Print this page

Charging The Batteries - HP T1500 xr Installation Instructions

Extended runtime module
Hide thumbs Also See for T1500 xr:

Advertisement

Checking the Battery
Recharge Date
Before unpacking the ERM, check the battery recharge date
specified on the battery recharge date label that is affixed to the
shipping carton.
IMPORTANT: Do not use the battery if the recharge date has passed. If the
date on the battery recharge date label has passed without the battery being
recharged, contact an HP authorized service representative for directions.
NOTE: The following label is only an example date. The date on your carton
may be different.
THIS PRODUCT CONTAINS
A NONSPILLABLE BATTERY
Next Recharge Date:
14-DEC-04
Please refer to Maintenance Section
of Owner's Manual enclosed inside
Kit Contents
Documentation
• Important Safety Information guide
• International Regulatory Compliance guide
• This document
ERM
• ERM chassis
Cables
• ERM power cable (attached to unit)
Preparing for Installation
Powering Down the UPS
To power down the UPS:
1. Shut down all load devices.
2. Press the Standby button to take the UPS out of Operate mode.
Power to the load receptacles ceases.
3. Disconnect the UPS from utility power.
4. Wait at least 60 seconds while the UPS internal circuitry
discharges.
Unpacking the ERM
Carefully remove the kit contents from the shipping box following
proper safety guidelines. Verify that all components are present.
Completing the ERM Assembly
Connecting the ERM to the UPS
1. Verify that the power to the UPS is off.
2. Plug the ERM cable into the connector located at the rear of the
UPS in the lower left corner.
NOTE: UPS appearance varies depending on the particular UPS ordered.
Refer to the UPS user guide for the specific ERM connector location.
3. To install a second ERM, plug the cable from the second ERM
into the socket at the rear of the first ERM.

Charging the Batteries

Allow the batteries to charge before putting the ERM into service.
IMPORTANT: The battery pack charges to:
90% of its capacity within 4 hours.
100% of its capacity within 24 hours.
Charge the batteries for at least 24 hours before using them to supply
power to your devices.
For more information, refer to the HP website at
www.hp.com/products/ups

Advertisement

loading

This manual is also suitable for:

T2200 xr