Advertisement
Stream Video Recorder - (ADC-SVR122) Installation Guide
Pre-Installation Checklist
• SVR (included)
• AC power adapter (included)
• Ethernet connection to broadband (Cable, DSL or Fiber Optic) Internet
• Login and Password for the Alarm.com account to which you will add the SVR
Add the Device to an Alarm.com Account
1. Using an Ethernet cable, connect the device to the network.
2. Connect the device's AC power adapter and plug it into a non-switched outlet. Wait for the SVR Status LED (on
front) to turn solid green.
3. Add the device to the account by either selecting the account in MobileTech OR by using a web browser and
entering the following URL:
4. Select the device from the video device list or type in its MAC address to begin adding the camera. The device's
MAC address is located on the bottom of the device.
5. Follow the on-screen instructions to finish adding the device. You may associate cameras to the device from the
Customer Website.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Stream_Video_Recorder_-_(ADC-SVR122)/Stream_Video_R
www.alarm.com/addcamera
Updated: Wed, 02 May 2018 19:46:29 GMT
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alarm.Com ADC-SVR122
Summary of Contents for Alarm.Com ADC-SVR122
- Page 1 • AC power adapter (included) • Ethernet connection to broadband (Cable, DSL or Fiber Optic) Internet • Login and Password for the Alarm.com account to which you will add the SVR Add the Device to an Alarm.com Account 1. Using an Ethernet cable, connect the device to the network.
- Page 2 Solid Green Local network and Internet connection Local network connection Flashing Green Local network connection only, no Internet Cameras not recording or hard drive Solid Red error Check LEDs on back of SVR https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Stream_Video_Recorder_-_(ADC-SVR122)/Stream_Video_R Updated: Wed, 02 May 2018 19:46:29 GMT...
- Page 3 If already installed, the device may need to be removed from the Flashing Green & Red Alarm.com account and re-added after a factory reset. To perform a factory reset, push the Reset button and release when flashing Green and Red (about 15 seconds).
- Page 4 Camera is connected and recording is paused Camera not recording Flashing Red Camera is disconnected or improperly configured Viewing Live and Recorded Video Locally 1. Ensure that you have followed the setup instructions in this guide. https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Stream_Video_Recorder_-_(ADC-SVR122)/Stream_Video_R Updated: Wed, 02 May 2018 19:46:29 GMT...
-
Page 5: Troubleshooting
Press and hold the Reset button until the SVR Status LED is flashing green and red (about 15 seconds), then release the button. The device will reboot with factory defaults. If the device was previously installed to an Alarm.com account, it will need to be deleted before it can be installed again. Questions? Visit alarm.com/supportcenter...
Need help?
Do you have a question about the ADC-SVR122 and is the answer not in the manual?
Questions and answers