D-Link KOMFY Quick Installation Manual

1. Turn O Circuit Breaker
Turn off the power to the light switch at the
main circuit breaker or fuse box.
Important: Flip your light switch a few
times to ensure the power is off.
2. Remove Faceplate from Old Switch
Take a picture for future reference
1 - Gang
1
Load
Wall Light Switch Outlet
Required. You need 1 load
for 1-gang.
2
Hot Wire (Live)
1
Required.
3
Neutral
3
Required, but not always
2
present.
STOP if you do not have it.
4
Ground
4
Optional, and not always
present.
2 - Gang
1
Load
Required. You need 2 loads
Wall Light Switch Outlet
for 2-gang.
1
2
Neutral
1
Required, but not always
present.
2 STOP if you do not have it.
3
3 Hot Wire (Live)
Required.
4
Ground
Optional, and not always
present.
3. Wire Labeling
Use the included wiring
labels and attach
the stickers to the
corresponding wires.
Green for "Ground", white
for "Neutral", black for
"Hot", red for "Upper
Light" and brown for
"Lower Light".
4. Remove Old Switch
Disconnect the old switch from the electrical box.
5. Wiring
Connect the wires from the Komfy Switch to the old switch wires.
1 - Gang
Wall Light Switch Outlet
KOMFY
The unused wire
should be protected
by a wire nut.
Wall Light Switch Outlet
KOMFY
Refer to Step 3 for
Color Wiring
Labeling
6. Attach Komfy Switch
Screw the Komfy Switch into the electrical box and then slide the power
selector to 1 or 2. 1-gang and 2-gang have different screws patterns as
shown below:
1 0 2 1 0 2
P O W E R P O W E R
Slide power
Slide power
selector to "1".
selector to "2".
1 - Gang: 2 - Gang:
2 middle screws 4 side screws
Turn the power back on at the circuit breaker or fuse box.
When the Wi-Fi LED lights up, press and hold the setup button for 5
seconds until the Wi-Fi LED starts blinking. When the Wi-Fi LED stops
blinking, the Komfy Switch is ready to be configured.
S E T U P
9. Attach Accessories
Attach the included faceplate to the Komfy Switch and then put the Komfy
Switch cover with click pads over the faceplate.
Komfy Switch Cover
Komfy Switch Faceplate
With Click Pads
Komfy iSwitch with
Click Pads
If you want to remove the the switch
cover, pull out at the corners either at the
top or bottom to remove it.
10.Con gure Komfy Switch
Download the Komfy App and sign up for a Komfy account. Tap the "Add
Device" button to complete the configuration.
Add Device
Add Device
New User Existing User