Download Print this page

Frost Protection - IDEAL Concord ESi 140 User Manual

Concord esi series
Hide thumbs Also See for Concord ESi 140:

Advertisement

To Shut Down the Boiler
1. For short periods
Set the boiler on/off switch (1) to OFF.
2. For longer periods
Set the boiler on/off switch (1) to OFF, wait 10 minutes then
switch the electricity supply to OFF. For longer periods the
entire system should be drained, including the domestic
hot water supply.
To Relight the Boiler
Refill the system if it has been drained, taking care to ensure
no air is in the boiler or system.
Repeat the procedure detailed in 'To light the boiler'.

Frost Protection

If frost is likely, leave the boiler thermostat at a reduced
temperature setting. Ensure external controls allow the boiler
to operate if necessary. Note that this may not protect remote
parts of the system, in which case a separate frost thermostat
should be fitted or the system drained and the boiler shut
down, as for Long Periods.
Ideal Stelrad Group pursues a policy of continuing improvement in the
design and performance of its products. The right is therefore reserved to
vary specification without notice.
Ideal Boilers, P .O. Box 103, National Ave, Kingston upon
Hull, HU5 4JN. Telephone: 01482 492 251 Fax: 01482
448 858. Registration No. London 322 137.
Ideal Consumer Helpline Tel: 01482 498 376
Boiler Overheat Thermostat
Boiler overheating is detected by the overheat thermostat
connected to the boiler control module. If the boiler overheats, it
will shut down the burner but the circulating pump will continue
to run. The display may show
Press the safety thermostat reset button, under the screw top
cap (4), and the burner will relight. If the fault recurs, turn off the
boiler and consult a recognised installer (CORGI registered for
gas-fired boilers.)
Escape of Gas
Should a gas leak or fault be suspected contact your local gas
supplier without delay.
Do NOT search for gas leaks with a naked flame.
C l e a n i n g
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains use a damp cloth and
mild detergent.
DO NOT use abrasive cleaning materials.
www.idealboilers.com
until the water cools.
November 2007
204041 A01

Advertisement

loading