PEUGEOT Elystar Workshop Manual page 19

- Remove the fuel gauge (5) with its seal using
tool P/N 756076 (and press on the tool in order to
squash the rubber seal and unscrew one quarter of
a turn)
- Unscrew and remove the fuel pump assembly (6)
with its seal using tool P/N 756056
Note: None of the components, fuel pump,
pressure regulator and strainer are removable.
It is only possible to clean the outside of the
strainer
Reassembly: Re-assemble in the reverse order to
dismantling
- Tighten the fuel pump with the ring spanner P/N
756056 in order to line up the arrow (A) with the
centre mark (B) on the tank
- Fit the fuel gauge with a new seal
Check: Using the diagnostic tool, check for fault
codes, clear them if necessary
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
WORKING ON 4-STROKE INJECTION SYSTEMS
Page : 19