Operating Chain Saw; Filling Oil Tank; Oiling Chain - Remington Electric Chain Saw Manual

SAW CHAIN TENSION
ADJUSTMENT
Continued
❸
Turn chain tensioning screw
clockwise to tension saw chain...
❹
Guide Bar
Pull chain to check tension. Guide
links should not come out of guide
bar groove...
❺
Make sure chain moves freely around
guide bar then tighten nut.
113005

OPERATING CHAIN SAW

FILLING OIL TANK

1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil. Note: For
3. Replace oil cap at once. Tighten oil cap firmly for
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw is not in use.
Empty oil tank after each use to prevent seepage.
Approx.

OILING CHAIN

1/8"
Manual Oil System
Always check oil level before using saw. Do not
attempt to operate the oil system while saw is in
operation. To oil chain, press squeeze bulb. Oil will
feed onto the guide bar and chain. Press squeeze
bulb at least once before each cut. Check oil level
often by looking at oil level through side of oil bottle
(see Figure 9).
Figure 9 - Oil Squeeze Bulb and Oil Bottle
Location
9
WARNING: Read and understand this
owner'smanualbeforeoperatingthissaw.
Make certain you read and understand all
Important Safety Information, pages 3
through 5.Improper use of this chain saw
can cause severe injury or death from
fire,electrical shock,or body contact with
moving chain, or falling wood.
temperatures below 30°F, use SAE #10 oil. For
temperatures above 75°F, use SAE #40 oil.
good seal. This will avoid oil seepage from tank.
Oil Bottle
Oil Squeeze Bulb
Continued
www.desatech.com