Sangoma Vega 4x4 Installation Manual

4. MODULE ACTIVATION
The following steps will guide you through the software process to activate the
module and all its ports.
A) Log into your Vega 4x4 webGUI by typing its IP address inside the URL of a
browser of your choice
B) A window will pop up indicating there is a hardware change within the Vega.
This message is normal as the module was added.
C) A factory reset of the Vega 4x4 is required at this point to allow the unit to
fully detect the new ports. Click the 'factory reset' button visible near the
bottom of the window (See Diagram below).
Vega 4x4 Core Board
Vega 4x4 Board
Vega 4x4 Module
5. RESTORE YOUR CONFIGURATION
A) A restore of your con guration is now required. Navigate to 'System >
Con guration and click Choose File where it says 'Send File to Gateway' . A
window will pop up allowing you to search for the backup you previously
created (if you did not alter the name of the backup it will be called 'con g.txt')
B) Once selected click the 'Upload' button which will restore the Vega to previous
con guration
C) You will be required to Apply and Save settings
With the Vega now ready, you may now con gure the new ports on your Vega 4x4.
Refer to the Vega 4x4 Quick Start Guide to continue con guration of the ports.
100 Renfrew Drive, Suite 100, Markham ON L3R 9R6 Canada
+1 905 474 1990 or 1 800 388 2475 (toll free in N. America)
Sangoma.com © 2017 Sangoma Technologies Proprietary
Note: Save your
existing con guration if
you have not done so,
as described in Step 2.
If you do not perform a
back up, your existing
con guration will be
lost.
sales@sangoma.com
Vega 4x4
MODULE INSTALL
FIELD UPGRADE
INSTALLATION MANUAL