Advertisement
Thank you for purchasing the Vega 4x4 module. Based on your order, your package
includes 1 x FXO/FXS/Audio/GenGen module.
The following steps will guide you through the physical installation of the module
into the chassis of the Vega 4x4 as well as WebGUI recon guration to activate.
Safety Warnings
Warning: The Vega 4x4 must be grounded before attempting the
below steps. (I.e., Touch unpainted metal to avoid destroying the
Vega Gateway with electrostatic discharge, work on non-carpeted
areas, etc.)
DO NOT ATTEMPT TO INSTALL THE MODULE WHILE THE VEGA 4x4 IS POWERED ON
1. REVIEW PACKAGE CONTENTS
Your packaging will include the following:
•
1 x Module (FXS/FXO/Audio/GenGen)
NOTE: The mounting screws were included in the Vega 4x4 chassis packaging.
2. BACKUP YOUR CONFIGURATION
Note: For new Vega 4x4 installations without any user con guration, you may skip
this step and move to step 3.
To save a backup of the current con guration navigate to 'System > Con guration'
and click Download. A window will prompt you to save con g.txt to your local
system (this is the complete backup of your Vega 4x4).
3. INSTALL THE MODULE
Preparation
A) Power down the Vega Gateway and remove the power cord from the unit.
B) Place the Vega Gateway on a at surface with the front of the unit facing
towards you
C) Verify the Vega Gateway is grounded.
D) Using a screwdriver remove the screws holding the top cover of the Vega
Gateway in place (see diagram 1)
E) Remove the top cover by using light pressure and pressing down near the front
of the Vega Gateway and pushing toward the rear of the unit. (See diagram 2)
F) With the cover removed the module slots are visible (see diagram 3)
Diagram 1
Diagram 2
Installation
A) Remove the module from its packaging and carefully identify the pins located
on the rear side .
B) Carefully align the module, over the pin connectors located on the Vega 4x4
board, on the rst available slot location (starting from the lowest port range
to highest), as seen in diagram 4.
C) Press rmly down on the module to insert . If the module is not tting, cease
pressure and attempt to re-alight before attempting again.
D) Once the module is seated in place locate the screw package (provided with
the chassis packaging) and insert them in the holes located at each corner of
the module, with a screw driver (see diagram 5)
E) Re-install the Vega Gateway cover by placing the cover ontop of the unit and
with light pressure slide to the front and lock in place.
F) Re-install the cover screws (see diagram 1). Do not over-tighten the screws to
avoid damaging the Vega Gateway.
Diagram 4
Diagram 3
Diagram 5
Advertisement
