Starting Up The Unit; Starting Up The Navigation System - Pioneer AVIC-Z910DAB Operation Manual

NOTE
The remote control may not function properly in direct sunlight.
Important
• Do not store the remote control in high temperatures or direct sunlight.
• Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator.

Starting up the unit

1
Start the engine to boot up the system.
The [Select Program Language] screen appears.
NOTES
• From the second time on, the screen shown will differ depending on the previous conditions.
• From the second time on, enter the password for the anti-theft function if the password entry
screen appears.
2
Touch the language.
3
Touch .
The [Speaker Mode Settings] screen appears.
4
Touch the speaker modes.
[Standard Mode]
4-speaker system with front and rear speakers, or a 6-speaker system with front and
rear speakers and subwoofers.
[Network Mode]
3-way system with a high range speaker, middle range speaker and subwoofer (low
range speaker) for reproduction of high, middle and low frequencies (bands).
WARNING
Do not use the unit in Standard Mode when a speaker system for 3-way Network Mode is
connected to the unit. This may cause damage to the speakers.
5
Touch .
The [DAB ANTENNA POWER SETTING] screen appears.
6
Touch [Yes] then [OK] to use the DAB aerial power (page 42).
7
Touch [OK].
The top menu screen appears.
NOTE
Once the speaker mode is set, the setting cannot be changed unless this product is restored to the
default settings. Restore the default settings to change the speaker mode setting (page 76).
Switching the speaker mode
To change the speaker mode, you need to restore this product to the default settings.
1
Restore the default setting (page 76).

Starting up the navigation system

When you use the navigation function for the first time, an initial setup process starts
automatically. Follow the steps below.
TIP
You can change the language later using [Regional] in the [Settings] screen. Other settings can be
restarted later using [Start Configuration Wizard] in the [Settings] screen.
1
Press .
2
Touch .
3
Touch the language that you want to use on the navigation screen, then touch
[Select].
4
Read the terms carefully, check the details, and then touch [Accept] if you agree
to the conditions.
5
Touch [Next].
6
Touch the language that you want to use for voice guidance messages, then
touch [Next].
7
If needed, modify the unit settings, then touch [Next].
8
If needed, modify the default route planning options, then touch [Next].
9
Touch [Finish].
7
En