Operation - Hayward HLWIRELESS Owner's Manual

version numbers differ, upgrade the Wireless Terminal by following the firmware upgrade procedure
described in the OmniLogic Operation Manual or the included Quickstart Guide. When searching
Hayward's website for the latest firmware, note that the Wireless Terminal uses the same firmware
file as the Wired Terminal. If a Wired Terminal is also used in the system, the firmware should always
be upgraded at the same time as the Wireless Terminal. After firmware upgrades are complete, the
firmware version of the MSP, Wired and Wireless Terminals should all be the same.
IMPORTANT: the Wireless Terminal must be in the charging cradle while performing a firmware upgrade.
You can now begin operating your Wireless Terminal.
With the Wireless Terminal now communicating with the OmniLogic, verify that it is responsive at
the locations where it will be used. Send commands and evaluate performance at all locations. If
there are issues with signal strength, you may need to consider adding a repeater or relocating your
home's access point.
Daily Use
The Wireless Terminal has been tested to be water resistant to 1 foot (12") submersion and is designed
to float if placed into the pool or spa. For best results, and to protect it from accidently exceeding its
rated depth, we advise that the unit be kept by the pool or spa, rather than in the water. This location
offers maximum convenience and is still safe if splashed. For best results, limit exposure to direct
sun and prevent leaving the Wireless Terminal in an area that will get excessively hot. At the end of
the day, return it to its charging cradle which should be located indoors or out of the elements. To
prevent corrosion, always dry off the Wireless Terminal before inserting it into the cradle.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
component
MSP
Waterproof
Wired Wall Mou...
EcoStar pump
firmware upgrade
config wizard
display
backup config
F POOL
º
heating
configuration
favorites
F
º
alarm lights
daylight features

Operation

msp id:3233
HUA
0-0-0-0
MP 1-65-0-2a-d4
3-10-0-0-1
31-2-0-0-b1
10-0-0-0-54
restore config
SYSTEM
configuration
system info
web server
wired networking
themes
config
version
R2.0.0
R.1.0.2
R2.0.0
R2.0.0
B1.0.16
4