Hayward HLWALLMOUNT Owner's Manual
  1. Manuals
  2. Brands
  3. Hayward Manuals
  4. Touch terminals
  5. HLWALLMOUNT
  6. Owner's manual
Hayward HLWALLMOUNT Owner's Manual

Hayward HLWALLMOUNT Owner's Manual

Wired wall mount terminal
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

092523 RevA
Wired Wall Mount Terminal
Touchscreen Terminal for OmniLogic
Owner's Manual
Contents
Description............................2
Installation............................3
Configuration.........................6
Operation..............................6
HLWALLMOUNT
Hayward Pool Products
620 Division Street, Elizabeth NJ 07207
www.hayward.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HLWALLMOUNT and is the answer not in the manual?

Questions and answers

Related Manuals for Hayward HLWALLMOUNT

Summary of Contents for Hayward HLWALLMOUNT

  • Page 1 092523 RevA Wired Wall Mount Terminal Touchscreen Terminal for OmniLogic Owner's Manual Contents Description......2 Installation......3 Configuration......6 Operation......6 HLWALLMOUNT Hayward Pool Products 620 Division Street, Elizabeth NJ 07207 www.hayward.com USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 2 (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Hayward could void the user’s authority to operate this equipment.

  • Page 3: Before You Begin

    • tools for mounting, small flathead screwdriver for screw terminals The HLWALLMOUNT must be mounted indoors or in a weather protected area (rain should never be in contact with the touchscreen). When considering a potential mounting location, survey the wiring route from the OmniLogic to the HLWALLMOUNT.
  • Page 4 1. Remove the remote terminal wallplate from the cover by inserting a screwdriver in the slot shown below. Lift up on the cover while pushing gently with the screwdriver. Push Screwdriver blade through slot and pull up cover USE ONLY HAYWARD GENUINE REPLACEMENT PARTS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 5 Parallel: Two HLWALLMOUNTs are wired back to the OmniLogic main unit (connection made at OmniLogic) and both can be at the maximum distance. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
  • Page 6 Daisy Chain: The second (furthest) HLWALLMOUNT is wired to the first (connection made at first HLWALLMOUNT) and the second HLWALLMOUNT must not exceed the maximum distance from OmniLogic. Connect 1 to 1, 2 to 2, etc. After wiring is complete, reinstall the HLWALLMOUNT cover. Reinstall the OmniLogic dead front and restore power to the OmniLogic.
  • Page 7 When the OmniLogic first starts HLWALLMOUNT should automatically be discovered and configured. No input is required from the user. To verify that the OmniLogic has discovered the HLWALLMOUNT, go to the local terminal (touchscreen on the OmniLogic) and follow the procedure below. There should be a line entry showing the HUA and version.
  • Page 8 Hayward is a registered trademark and OmniLogic is a trademark of Hayward Industries, Inc. © 2013 Hayward Industries, Inc. All other trademarks not owned by Hayward are the property of their respective owners. Hayward is not in any way affiliated with or endorsed by those third parties.

Table of Contents