Warning: Safety Precautions - Remington 490 Operating Instructions Manual

Warning: Safety
WARNING ICON G 001
The following pages contain detailed warnings, cau-
tions, and rules of safe operation. Read carefully and
become familiar before operating to avoid serious injury.
We expressly disclaim any liability for any injury to
persons or damage to property which result from your
failure to take the precautions contained in this manual.
WARNING: This tool is designed only for use by qualified
WARNING ICON G 001
operators. Qualification is obtained through a thorough under-
standing of the Safety Warnings and operating instructions as
defined in this operating manual. NOTE: The labor regula-
tions of many states require that the operator of this tool on a
job site be thoroughly trained and certified for competence
prior to operating this tool. For certification procedures, call:
DESA Specialty Products™ Technical Services Department,
1-800-858-8501 or visit www.desatech.com.
BEFORE USING
1. ALWAYS handle the tool as if it were loaded. Before starting
work, check that the tool is unloaded and the muzzle is clear.
NEVER load a tool unless it is going to be used.
2. ALWAYS inspect to make sure the tool is working prop-
erly. If the tool does not work properly, remove from
service and tag DEFECTIVE. DO NOT use the tool again
until it has been properly repaired.
3. Operators and bystanders must ALWAYS wear ANSI/
OSHA approved eye and ear protection.
101274
Precautions
?
489-03
489
G 018
489-07
?
3
489-04
G 018
489-06
489-08