Figure 24. Installing the 2.5-inch storage drive
7. Install the storage drive bracket.
Figure 25. Installing the storage drive bracket
8. Connect the signal cable and the power cable to the new storage drive.
9. Reinstall the removed parts. To complete the replacement, see "Completing the parts replacement" on
page 43.
Replacing the card reader
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove the computer cover. See "Removing the computer cover" on page 16.
2. Remove the front bezel. See "Replacing the front bezel" on page 17.
3. Remove the optical drive. See "Replacing the optical drive" on page 18.
4. Remove the storage drive bracket. See "Replacing the storage drive" on page 20.
5. Disconnect the card reader cable from the system board.
6. Replace the card reader.
.
Chapter 4
Replacing hardware
23